ANALISIS KEKUATAN RANGKA BATANG KOMPONEN MESIN PRESS KEMASAN MINUMAN LOGAM NON FERRO

Article Sidebar

Cover Vol 17 No 2
PDF
Published: Dec 30, 2021
DOI: https://doi.org/10.24912/poros.v17i2.20044
Keywords:
Truss press machine maximum strength

Main Article Content

Mikael Sean Hendito
Daniel Joachim
Program Studi Teknik Mesin, Fakultas Teknik Universitas Tarumanagara, Jakarta
Harto Tanujaya
Sobron Yamin Lubis

Abstract

Beverage cans is a sheet coated of steel with tin (Sn). It is a steel sheet container coated with thin white tin that has a content value of 1.00% to 1.25% of the total weight of that can. The method used in this design is to make a truss design using special design software then determine the constituent materials and dimensions of the truss then do a strength analysis of the truss. The purpose of this design is to determine the maximum strength of the press machine truss that can be accepted with a certain force. This design starts from making a truss design with dimensions of length, width, and height are 260 mm, 100 mm, and 500 mm, respectively. The result obtained from this design are that the bending moment obtained is 43.8 MPa, the total moment of inertia is 38,286.9 mm4, the maximum stress in the truss is 23 MPa while the allowable stress according to the frame material made of Hollow iron is 124 MPa.

Article Details

Issue
Vol. 17 No. 2 (2021): Jurnal Ilmiah Teknik Mesin Poros
Section
Articles
Creative Commons License

This work is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License.

Creative Commons License
This work is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License.

References

S. Mulyadi. 2011. “Karakteristik Sifat Mekanis Kaleng Minuman”. J. Ilmu Fis.. Univ. Andalas, vol. 3, no.2, pp. 68 – 74.

J. Gregory. 2005. Materials Selection for Mechanical Design I A Brief Overview of A Systematic Methodology. P. 646

Cambridge University. 2003. Materials Data Book. Cambridge University Engineering Department.

Linervina. 2016. “Tegangan Geser dan Momen Bending”. https://fliphtml5.com/eaoo/vzwr. Pages 1 – 14. Diakses pada 22 Desember 2021.

H. Judul dan Y. R. Nugroho. “Besaran Karakteristik Penampang”. Fakultas Teknik Jurusan, Teknik Sipil, Universitas Brawijaya.

R. Khurmi, J.K. Gupta. 2005. A Textbook of Machine Design. Eurasia Publishing House (PVT,) LTD. Ram Nagar, New Delhi.

Agustinus Purna Irawan. 2007. “Diktat Kuliah Mekanika Teknik (Statika Struktur)”.

Joseph P. Vidosic. 1957. Machine Design Project. Ronald Press Company, the University of Michigan.

R. G. Budynas, J. K. Nisbet. 2012. Mechanical Engineering Design. The McGraw-Hill Companies, Singapore.